We are open Monday to Friday
Product Hotline - 01993 704 981
Local call rate - 0845 363 7131

A10 Acoustic Carpet Underlay Technical Specification & Install Guide

When installing the A-10 lay the gripper rods as normal. Then roll out the A-10 with the rubber side facing the floor. Lay the carpet on top of the A-10 and treat the A-10 as a normal underlay.

YOU DO NOT NEED TO USE A STANDARD UNDERLAY WITH THIS PRODUCT.

.
A-10 Acoustic Carpet Underlay Technical Specification
Technical Details
Nominal Weight: 2455gm/m2 72oz/yd2
Static Loading
Thickness Loss: 20.55
BS.4939 Retained Factor 79.55%
Dynamic Loading Thickness Loss: 14.4%
Compression Before Dynamic Loading 172J/m2
BS.4098/BS.5808 After Dynamic Loading 124J/m2
Retained Loading 72%
Tensile Strength 10mm 7/16″
Strength 170N
BS.2576/BS.5808 Elongation at 40N 3.8%
Resistance to Cracking No cracks visible
Flammability
BS.4790 Hot Nut Low Radius
Methenamine Pill ASTM D2859-76 Pass
ISO Method BS.6307 Char Length 16mm
Flame Retardency BS.4790:1987 Pass Acousticel
A10 conforms to flame retardency test BS4790: 1987
Thermal Conductivity
BS.4745 Resistance Factor 2.9 togs
Impact Sound Improvement Index
ISO Method 140 part 8 Resistance Factor Delta Lw.34Db
Acousticel A10 meets the regulatory standards for impact insulation when glued to a concrete floor. The tested sample meets the minimum performance requirements of BS5808: 1991 (1996)
Classification: Heavy Contract/Heavy Domestic BS.5808
Fitting should meet the British standard code of practice BS.5325 and be undertaken by experienced carpet fitters and should be laid rubber to the floor surface. Sub floors should be dry, clean and free of oil, grease and damp.The contractor shall be responsible for the examination and acceptance of all conditions and project suitability prior to the installation.

 

Click here for ACOUSTICEL A10 HEALTH & SAFETY INFORMATION SHEET