We are open Monday to Friday
Product Hotline - 01993 704 981
Local call rate - 0208 0909586
PRODUCT NAME: Acoustic Sealant
APPLICATION: Fire resistant sound blocking sealant.
SUPPLIER: Sound Service (Oxford) Ltd, Crawley Mill, Dry Lane, WITNEY, OX29 9TJ Tel. 0845 363 7131
Fax. 0845 363 7151
COMPOSITION COMMENTS
Aqueous acrylic emulsion with mineral fillers and auxiliaries.
Not regarded as a health or environmental hazard under current legislation.
INHALATION
Move the exposed person to fresh air at once. Get medical attention if any discomfort continues.
INGESTION
Immediately rinse mouth and drink plenty of water. If person becomes uncomfortable or if ingested in large amounts (50-100 ml for an adult
person): Take to hospital along with these instructions.
SKIN CONTACT
Remove affected person from source of contamination. Remove contaminated clothing. Wash the skin immediately with soap and water. Get
medical attention if any discomfort continues.
EYE CONTACT
Make sure to remove any contact lenses from the eyes before rinsing. Promptly wash eyes with plenty of water while lifting the eye lids.
Continue to rinse for at least 15 minutes. Get medical attention if any discomfort continues.
EXTINGUISHING MEDIA
Water spray. Foam, carbon dioxide or dry powder.
PERSONAL PRECAUTIONS
Wear appropriate protective clothing.
ENVIRONMENTAL PRECAUTIONS
Avoid discharge into drains, water courses or onto the ground.
SPILL CLEAN UP METHODS
Shovel into dry containers. Cover and move the containers. Flush the area with water. Wash thoroughly after dealing with a spillage.
USAGE PRECAUTIONS
Avoid spilling, skin and eye contact. Observe good industrial hygiene practices.
STORAGE PRECAUTIONS
Store in tightly closed original container in a cool, dry well-ventilated place.
PROTECTIVE EQUIPMENT
ENGINEERING MEASURES
No particular ventilation requirements.
HAND PROTECTION
Use suitable protective gloves if risk of skin contact.
EYE PROTECTION
Not generally required.
HYGIENE MEASURES
DO NOT SMOKE IN WORK AREA! Wash at the end of each work shift and before eating, smoking and using the toilet. Wash promptly if skin becomes contaminated. Promptly remove any clothing that becomes contaminated. When using do not eat, drink or smoke.
APPEARANCE Thixotropic paste.
COLOUR White
ODOUR Slight odour
SOLUBILITY Miscible with water.
RELATIVE DENSITY ~ 1.65 @ 20″C pH-VALUE, CONC. SOLUTION ~8
VISCOSITY 7,000 – 10,000 Ps @ 20″C FLASH POINT (°C) Not determined
STABILITY
Stable under normal temperature conditions and recommended use.
CONDITIONS TO AVOID
Avoid excessive heat for prolonged periods of time.
HAZARDOUS DECOMPOSITION PRODUCTS
No specific hazardous decomposition products noted.
TOXIC DOSE 1 – LD 50 Not determined
INHALATION
No specific health warnings noted.
INGESTION
No harmful effects expected in amounts likely to be ingested by accident.
SKIN CONTACT
Skin irritation is not anticipated when used normally.
EYE CONTACT
May cause irritation to eyes. Will not injure eye tissue.
HEALTH WARNINGS
This product has low toxicity. Only large volumes may have adverse impact on human health.
ECOTOXICITY
Not regarded as dangerous for the environment.
LC 50, 96 Hrs, FISH mg/l Not determined
MOBILITY
The product is miscible with water. May spread in water systems.
BIOACCUMULATION
No data available on bioaccumulation.
DEGRADABILITY
There are no data on the degradability of this product.
DISPOSAL METHODS
Dispose of waste and residues in accordance with local authority requirements.
GENERAL The product is not covered by international regulation on the transport of dangerous goods (IMDG, IATA,ADR/RID).
RAIL TRANSPORT NOTES Not Classified.
RISK PHRASES NC Not classified.
SAFETY PHRASES NC Not classified.
STATUTORY INSTRUMENTS
Chemicals (Hazard Information and Packaging) Regulations. Control of Substances Hazardous to Health.
APPROVED CODE OF PRACTICE
Classification and Labelling of Substances and Preparations Dangerous for Supply.
GUIDANCE NOTES
Workplace Exposure Limits EH40. CHIP for everyone HSG(108).
REVISION COMMENTS
General review
REVISION DATE 25/10/05
REV. NO./REPL. SDS GENERATED 17/02/04
SDS NO. 10202
DISCLAIMER
This information relates only to the specific material designated and may not be valid for such material used in combination with any other materials or in any process. Such information is, to the best of the company’s knowledge and belief, accurate and reliable as of the date indicated. However, no warranty guarantee or representation is made to its accuracy, reliability or completeness. It is the user’s responsibility to satisfy himself as to the suitability of such information for his own particular use.